Choose a craft article:

Flower Arrangements
Make A Tiara
Ivy Bowl Candle Holders
Floral Wreaths
Rose Favour & Placecard Holder
Hat Box Card Holder
Candy Flower Pots
Toss Bouquet
Tartan Guestbook
Envelope Favours
Floral Crown
Decorated Acrylic Frames
Trinket Box
Hand Painted Flutes
Hand Painted Wine Glasses
Photo Guestbook
Invites
Stamped Pillow Box Favour
Glass Tags
Flower Balls
Handmade Paper Invitations
Bridal Bears
Wish Rocks
Bridesmaids Jewellery
Flower Girl Basket
Floral Centrepiece
Destination Wedding Invite
Elegant Card Box
Wedding Pew Markers
Dollarstore Topiary
Fall Centrepiece

Ring Bearer's Kitty
Fall Themed Card and Flower Girl Baskets
Hurricane on Fire Centrepiece
Guest Pen and Holder
Picture Magnet Favours


Babbling Brides Bulletin Board
Frugal Wedding Crafts
Frugal Feedback
Advertise With Us
About The Frugal Bride

Back to Home Page

FOLLOW US:

All photographs supplied by
Elementz of Fotographie

Materials Needed

Wood box with cut out on top
Acrylic Paint
Clear Varathane
Mini Glue Gun
Glue Sticks
Cardboard
Cotton Batten (amount will vary on size of box chosen)
Material For Lining of Box (I used White Velvet amount will vary on size of box chosen)
Mini Screw Driver
Invitation
Paint Brushes
Masking Tape


Instructions

  1. Remove hardware from the box
  2. Tape off the cut out so as not to get any paint on it
  3. Paint the box with Acrylic Paint (Alternative you can use wood stain if wanting the natural look)
  4. Wait for that to dry and apply a second coat
  5. Later you apply one coat of Varathane ,follow instructions on the can for the second coat
  6. Measure the interior of your box
  7. Cut cardboard rectangles to cover the bottom and five sides cut them just slightly smaller than actual size
  8. Wrap and glue two layers of cotton batten around each the cardboard pieces
  9. Cut material to overlap the edges of the cardboard by an inch and glue around the cardboard
  10. Place glue on the back of each piece and put in the side pieces first snugly fitting in the bottom piece last
  11. Remove tape from the cut out part
  12. Glue gun the edges of the invitation and fit invitation so it shows well
  13. Put hardware back into place



The finished product!

Bulletin Board | Frugal Wedding Crafts | Frugal Feedback | Advertise With Us | Site Index | Photo Galleries
Copyright © 2011 Frugalbride.com