Materials Needed

5x7 acrylic frames (or any size that you want)
low temp mini glue gun
mult-temp mini glue sticks
assorted buttons (we are using these because it will be my new last name but
you can use anything)
small silk flowers (any colour of your choice)
1/8" 3mm ribbon (any colour)
scissors

Instructions

1. Heat up your glue gun and get all nescessary supplies ready. eg.silk flowers, ribbon, frames.

2. Cut ribbon into approximately 18 inch pieces.

3. When glue gun is ready start in your top left hand corner of your frame hot glue your ribbon to the corner on an angle leaving approximately 7 inches of ribbon at the top and 11 inches on the left hand side. (don't worry if there is glue coming out or the sides of the ribbon because it will
be covered with silk flowers)

4. You will want to make 3 curls on the left hand side and 2 on the top.

5. Make your first curl 1/3 of the way down your frame on the left hand side and about 1 inch in and glue down. Do this 2 more times on the left hand side.

6. Make 2 curls on the top of the frame using the same method as the left hand side. (It may be a little tricky at first but once you get the hang of it it is a breeze)

7. Place 2 small silk flowers of your choice and style and hot glue 2 in the top left hand corner

8. Place 1 small silk flower on the spot where you hot glued each curl.

9. At the very bottom we used buttons instead of another flower beacause button will be my married name. You can use anything here, hearts, shells or the theme of your choice.

10. Cut off any extra ribbon hanging over the ends

11. You may use these frames as placecard holders as we are, or you may use they as favours and put a picture in of you and your new hubby to be.

The finished product!